Ahh some Hot Tub Cleaner 2oz (4 Packs)

AHH-Some Spa / Hot Tub Plumbing Jet Cleaner 

Ahh-Some is an eco-friendly biological cleaner and clarifier specifically formulated to eliminate pipe and jet residue. It effectively cleans the plumbing systems in hot tubs and jetted tubs, maintaining clear and healthy water flow in your heated water equipment.Your hot tub sits at high temperatures for long periods of time and biofilm will start collecting to your pipes.

Regardless of the chemicals in use, biofilm buildup is inevitable. Ahh-Some is formulated to rapidly break down and remove biofilm from your spa’s plumbing, visibly lifting it to the surface and walls within minutes. It’s best applied when preparing to drain your spa for a fresh water refill, ensuring cleaner and healthier water circulation.

SPA OWNERS:  This product is used in addition to the chemical lines you are currently using and is compatible with all chemical lines! 

Ahh-Some Benefits

•  Filter and plumbing lines stay “whistle clean”.
•  Salt generator cells last longer (you can decrease the production level with   Ahh-Some Water Clarifier & Bio-Cleaner).
•  Less red-eye and green-hair syndrome.
•  Liners will last longer and remain supple (not dry out as fast).
•  Aggregate surfaces will be smoother with fewer calcium barnacles.
•  Heater, heat pump, and solar systems will last longer due to lower sanitizer levels.
•  Pool cleaners have fewer particulates to capture lowering turbidity levels.
•  YOU ARE DOING SOMETHING POSITIVE FOR YOUR FAMILY AND FRIENDS.

Ahh-Some Directions 

1. Adjust water chemistry to proper balance. Add additional sanitizer before purging.

2. Remove all pillows and headrests if removable.

3. Add 3/4 level teaspoon per 100 gallons of Ahh-Some.

4. Remove filter(s) from hot tub filter well. Hose them off. Place them into the hot tub.

5. Run the pump(s) and blower to attain maximum circulation. Be sure to open-air intake valve(s). Note: Foaming will occur soon after pumps are turned on. This is Normal.

6. If Foaming is excessive, turn the pump(s) off for a few minutes. Turn on again soon after.

7. Run the jets and blower (if equipped) for 20-30 minutes opening ALL jets and waterfalls.

8. Shut the system down. Wipe away clinging gunk and grime from the shell with a towel.

9. Drain the tub. Be sure to dump as much of the dirty water as possible. It is Ok to drain on the ground, in flower gardens, or grass. Do NOT drain into lakes or a stream.

10. Remove the filter(s) from the hot tub and hose clean. Rinse the tub with fresh water.

11. Use rubber gloves and a good cleaner while rinsing and wiping the shell.

12. Mix 1/8th of a level teaspoon of Ahh-Some with 32 ounces of water in a trigger spray bottle to make a wonderful cleaner for the acrylic shell wipe-down. (Optional)

13. Wipe the hot tub as clean as possible, getting the sticky gunk off the interior finish.

14. Fill the hot tub with water to the proper level; replace the filter(s) into the filter well. Balance water and add proper sanitizer. Be sure to use a reliable test kit for proper chemistry.

15. Repeat every 4-6 months. Some tubs may need consecutive and additional purges.

Ahh-Some Ingredients

Ingredients are on this SDS Sheet CLICK HERE